Extreme Networks ISM Provision Manual de usuario descargar pdf (Pagina 40)

1-36 ISM Provision Installation Guide

Installing ISM Provision

5828 pts/6 0:00 devcomm

If you did not install the device communicator on the server machine, you will need to

launch the NIM client and add the device communicator hostname to the server. Follow

the instructions in the next section, “Launching the NIM Client”, to launch the NIM

client, and then follow the directions in the subsequent sections, “Add Device

Communicator Hostname to Server” and “Start Device Communicator” to complete the

process of using ISM Provision.

Launching the NIM Client

You can launch the NIM client by navigating to and double-clicking its icon, using a

graphical file manager. You will find the program, “nim”, in the

bin subdirectory of the

ISM Provision installation directory (typically,

/opt/extreme/ismprov).

Alternately, you may launch the NIM client from the command line. For example, if

your ISM Provision installation directory is

/opt/extreme/ismprov, you will type the

following command:

/opt/extreme/ismprov/bin/nim

Once you’ve launched the NIM client, you will see the login screen. The login screen

requires you to enter the hostname or IP address of the ISM Provision server and a

username and password. The default username is admin, and for the default password

leave the field blank.

If you installed the device communicator on a different host than the ISM Provision

server, you will need to use the NIM client to add the device communicator hostname

to the server. Without this, the server will not allow the device communicator to connect

and the device communicator will eventually exit. If the server and device

communicator are installed on the same host, the connection is managed automatically

and you will not need to do the following steps.

Add Device Communicator Hostname to Server. From the NIM client, select the

menu View>Server Administration. When the Server Administration view appears,

select the Add Device Communicator button (If the button is not visible, select the

Communicators tab near the top of the view). Type the hostname into the Host Name

field of the Create Device Communicator wizard, then select Finish near the bottom of

the wizard. Your entry should appear on the screen, and its status will likely be

displayed as “Not available” until you start the communicator.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 46

Sin comentarios

Extreme Networks ISM Provision Manual de usuario Pagina 40