Extreme Networks ExtremeWare Enterprise Manager Guía de usuario Pagina 176

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 432
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 175
10-6 E
XTREME
W
ARE
S
OFTWARE
U
SER
G
UIDE
E
XTREME
S
TANDBY
R
OUTER
P
ROTOCOL
S
TANDBY
S
WITCH
B
EHAVIOR
If a switch is in standby mode, it exchanges ESRP packets with other switches on that
same VLAN. When a switch is in standby, it does not perform layer 3 routing or layer 2
switching services for the VLAN. From a layer 3 routing protocol perspective (for
example, RIP or OSPF), when in standby for the VLAN, the switch marks the router
interface associated with the VLAN as down. From a layer 2 switching perspective, no
forwarding occurs between the member ports of the VLAN; this prevents loops and
maintains redundancy.
E
LECTING
THE
M
ASTER
S
WITCH
A new master can be elected in one of the following ways:
A communicated parameter change
Loss of communication between master and slave(s).
If a parameter that determines the master changes (for example, link loss or priority
change), the election of the new master typically occurs within one timer cycle (2
seconds by default). If a switch in standby mode loses its connection with the master, a
new election (using the same precedence order indicated previously) occurs. The new
election typically takes place in three times the defined timer cycle (6 seconds by
default).
F
AILOVER
T
IME
Failover time is largely determined by the following factors:
The ESRP timer setting.
The routing protocol being used for inter-router connectivity if layer 3 redundancy is
used. OSPF fail-over time is faster than RIP fail-over time.
The failover time associated with the ESRP protocol is dependent on the timer setting
and the nature of the failure. The default timer setting is 2 seconds; the range is 1 to 255
seconds.
If routing is configured, the failover of the particular routing protocol (such as RIP V1,
RIP V2, or OSPF) is added to the failover time associated with ESRP.
Vista de pagina 175
1 2 ... 171 172 173 174 175 176 177 178 179 180 181 ... 431 432

Comentarios a estos manuales

Sin comentarios