Extreme Networks BlackDiamond 10808 Guía de instalación descargar pdf (Pagina 20)

XFP Modules

Extreme Networks Pluggable Interface Modules Installation Guide

Installing an XFP Module

This section describes how to install an XFP module (Figure 3). You can install or remove an XFP

module in your Extreme Networks switch without powering off the system.

Figure 3: XFP Module

WARNING!

XFP modules contain Class 1 lasers. Invisible laser radiation can occur when laser connections are unplugged. Do

not stare into the beam. This device is compliant with FCC 21 CFR 1040.10 and EN60825-1 A2:2001.

CAUTION

To prevent ESD damage to the XFP module, always use an appropriately grounded ESD-preventive wrist strap when

installing or removing the module. Handle the module by its sides only. Never touch the card-edge connectors at the

insertion end of the module.

To install an XFP module:

1 Remove the XFP module from its antistatic container and remove the dust covers from the module

optical connectors.

If your module has a protective pad covering the card-edge connector, remove it. Store the antistatic

container, dust covers, and card-edge connector protective pad in a clean location from which they

can be easily retrieved if you need to uninstall the module.

2 Remove any rubber dust covers from the port on the module into which you are installing the XFP

module.

3 On the Summit XGM2-2xf option card, move the handle to an upright position to access the XFP

ports (see Figure 4).

SH_022

Card edge

connector

XFP Module

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 47 48

Sin comentarios

Extreme Networks BlackDiamond 10808 Guía de instalación Pagina 20