Extreme Networks BlackDiamond 10808 Guía de instalación descargar pdf (Pagina 28)

XENPAK Transceivers

Extreme Networks Pluggable Interface Modules Installation Guide

Figure 7: XENPAK Module

WARNING!

XENPAK modules contain Class 1 lasers. Invisible laser radiation can occur when laser connections are unplugged.

Do not stare into the beam. This device is compliant with FCC 21 CFR 1040.10 and EN60825-1 A2:2001.

CAUTION

To prevent ESD damage to the XENPAK module, always use an appropriately grounded ESD-preventive wrist strap

when installing or removing the module. Handle the module by its sides only. Never touch the card-edge connectors

at the insertion end of the module.

Installing a XENPAK Module

To install a XENPAK module:

1 Remove the XENPAK module from its antistatic container and remove the dust covers from the

module optical connectors.

If your module has a protective pad covering the card-edge connector, remove it. Store the antistatic

container, dust covers, and card-edge connector protective pad in a clean location from which they

can be easily retrieved if you need to uninstall the module.

2 Remove any dust covers from the port on the module into which you are installing the XENPAK

module.

3 Holding the module by its sides, insert the XENPAK module into the slot on the I/O module or

Summit option card.

4 Slide the XENPAK module as far back into the slot as possible, until you hear it click, indicating that

it is firmly attached.

5 Secure the XENPAK module to the I/O module or option card by turning the two captive screws

clockwise until the screws are hand-tight.

NOTE

To ensure that your XENPAK module is undamaged upon installation, you can correlate factory test data with your

installation site test data by consulting the average power reference values shown on the XENPAK module test data

sheet (Part No. 121074-00) enclosed with your module.

EWUG003B

Card edge

connector

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 47 48

Sin comentarios

Extreme Networks BlackDiamond 10808 Guía de instalación Pagina 28