Extreme Networks ExtremeWare XOS Command Especificaciones descargar pdf (Pagina 38)

100

101

38 ExtremeWare XOS 11.0 Concepts Guide

Accessing the Switch

If a ping request fails, the switch continues to send ping messages until interrupted. Press [Ctrl] + C to

interrupt a

ping request. The statistics are tabulated after the ping is interrupted.

Traceroute

The traceroute command enables you to trace the routed path between the switch and a destination

endstation. The

traceroute command syntax is:

traceroute [vr <vrid>} | <host>] {from <source IP address>} {ttl <number>} {port <port

number>} {icmp}

where:

• from source IP address uses the specified source address in the ICMP packet. If not specified,

the address of the transmitting interface is used.

• host is the hostname of the destination endstation. To use the hostname, you must first configure

DNS.

• ttl configures the switch to trace the hops until the time-to-live has been exceeded for the switch.

• port uses the specified UDP port number.

• icmp uses ICMP echo messages to trace the routed path.

host Specifies a IPv4 host to ping.

from Uses the specified source address. If not specified, the address of the transmitting

interface is used.

with record-route Sets the traceroute information.

Table 8: Ping command parameters (continued)

Parameter Description

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 369 370

Comentarios a estos manuales

Sin comentarios

Extreme Networks ExtremeWare XOS Command Especificaciones Pagina 38

Comentarios a estos manuales

Relacionado con productos y manuales para Software Extreme Networks ExtremeWare XOS Command