Extreme Networks Summit WM Series Manual de usuario descargar pdf (Pagina 3)

PN: 72-9958-00-A.doc Page 3

Product Limitations

1. Beacons are sent from the AP inconsistently; therefore you may see decreased

battery life on the handsets.

2. A hex-key is not supported with both WPA-PSK and WPA2-PSK. You must use a

passphrase for each.

3. Because the Controller configures a virtual subnet, broadcast data cannot be sent to

the handsets.

Installing Software & Configuration

1. If software upgrades are required, contact Extreme Networks Customer Support for

the latest version of software and instructions.

2. The current version of software installed can be found by opening a telnet session of

the AP, and typing the command ‘version’, or by looking at the configuration GUI

under Wireless APs then selecting the general tab for the AP in the field ‘s/w

version’.

If you encounter difficulties or have questions regarding the configuration process,

please contact your Extreme Networks representative or visit the web site

http://www.extremenetworks.com/solutions/applications/wireless.asp.

Initial Setup

1. The following instructions are for configuring a wireless controller and a number of

access points with no prior configuration.

2. All of the initial setup is done via a web interface. Connect a ‘Cross-Over’ Ethernet

cable directly from the Management Port of the controller to a PC’s Ethernet port.

3. Log onto the controller by opening a web browser and connect to

https://192.168.10.1:5825/. The default username is ‘admin’; the default password is

‘abc123’.

4. Do this step only if it is necessary to reset the controller back to its factory default

configuration. Browse to

WM-AD Configuration and select System Maintenance screen. Select

Reset database to factory default and reboot and click Apply. This will reset the database and

cause the controller to reboot. It will take three to four minutes before the controller

is finished.

1 2 3 4 5 6 7 8 ... 17 18

Sin comentarios

Extreme Networks Summit WM Series Manual de usuario Pagina 3