Extreme Networks Summit WMScanner Manual de usuario descargar pdf (Pagina 3)

Anritsu User’s Manual - Page

3 of 13.

2.2 Configure Summit WMScanner

From the Summit WMScanner menu, select “Measurement Survey”, “Record

New Data…”, choose the “Anritsu Site Master / MS2711 / MS2711A / S33XB / S33XC”

item from the “Select Measurement Mode” box located at the bottom of the dialog, and

then click “Next >>”. This will open the Configure Serial Port dialog box shown in

Figure 1.

Figure 1: Configure Serial Port dialog box

Referring to Figure 1, select the appropriate serial port number where the Anritsu

HHSA is attached (e.g., COM1, COM2, etc.) The baud rate should be 9600. The other

settings are grayed out because the HHSA does not support any other modes different

from those shown in the dialog box. After these have been accomplished, click OK and

the Anritsu MS2711 HHSA options dialog box shown in Figure 2 should be presented.

1 2 3 4 5 6 7 8 ... 12 13

Sin comentarios

Extreme Networks Summit WMScanner Manual de usuario Pagina 3