Extreme Networks Altitude 3500 Series Especificaciones descargar pdf (Pagina 557)

100

101

Altitude 3500 Series Access Point Product Reference Guide

557

Adopting an Adaptive AP Manually

To manually enable the access point’s controller discovery method and connection medium required for

adoption:

1 Select System Configuration > Adaptive AP Setup from the access point’s menu tree.

CAUTION

If deploying the access point as an AAP with a remote layer 3 configuration and the AAP is set for

controller auto discovery (primary/standby), the access point will un-adopt from its controller after a few

moments. To remedy this problem, ensure LAN1 has 802.1q trunking enabled and the correct management

VLAN defined.

2 Select the Auto Discovery Enable checkbox.

Enabling auto discovery will allow the AAP to be detected by a controller once its connectivity

medium has been configured (by completing steps 3-6)

3 Enter up to 12 Controller IP Addresses constituting the target controllers available for AAP connection.

The AAP will begin establishing a connection with the first addresses in the list. If unsuccessful, the

AP will continue down the list (in order) until a connection is established.

4 If a numerical IP address is unknown, but you know a controller’s fully qualified domain name

(FQDN), enter the name as the Controller FQDN value.

5 Select the Enable AP-Controller Tunnel option to allow AAP configuration data to reach a controller

using a secure VPN tunnel.

1 2 ... 552 553 554 555 556 557 558 559 560 561 562 ... 589 590

Comentarios a estos manuales

Sin comentarios

Extreme Networks Altitude 3500 Series Especificaciones Pagina 557

Comentarios a estos manuales

Relacionado con productos y manuales para Puntos de acceso wlan Extreme Networks Altitude 3500 Series