Extreme Networks Altitude 4600 Series Guía de instalación descargar pdf (Pagina 15)

Altitude 4600 Series Access Point Installation Guide

1 Orient the unit on the wall by its width or length.

2 Using the arrows on one edge of the case as guides, move the edge to the midline of

the mounting area and mark points on the midline for the screws.

3 At each point, drill a hole in the wall, insert an anchor, screw into the anchor the

wall mounting screw and stop when there is 1mm between the screw head and the

wall.

NOTE

When pre-drilling a hole the recommended hole size is 2.8mm (0.11in.) if the screws are

going directly into the wall and 6mm (0.23in.) if the provided wall anchors are being used.

4 If required, install and attach a security cable to the unit’s lock port.

5 Attach the Ethernet cable to the unit and to a controller with an 802.3af-compatible

power source.

6 Place the middle of each of the case’s mount slots over the screw heads.

7 Slide the case down along the mounting surface to hang the mount slots on the

screw heads.

8 Verify the unit has power by observing that the LEDs are lit or flashing.

Integrated Antenna Suspended Ceiling T-Bar Mount

Instructions

Ceiling mount requires holding the Altitude 4600 Series Access Point up against the T-

bar of a suspended ceiling grid and twisting the case onto the T-bar.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 46 47

Sin comentarios

Extreme Networks Altitude 4600 Series Guía de instalación Pagina 15