
Hardware Installation
Altitude 4600 Series Access Point Installation Guide
22
The LED behavior is determined by the version of software running on the controller
which the access point is connected to. The tables below show the LED patterns for
software version 4.x and software version5.x.
Software Version 4.x LED States
Software Version 5.x LED States
Task 5 GHz Activity LED (Amber) 2.4 GHz Activity LED (Green)
Unadopted Off Blinking at 5Hz
Normal Operation If this radio band is enabled:
Blink rate at 5 second interval
If this radio band is disabled: Off
If there is activity on this band:
Blink rate at a 1Hz
If this radio band is enabled:
Blink rate at 5 second interval
If this radio band is disabled: Off
If there is activity on this band:
Blink rate at a 1Hz
Firmware Update On Off
Locate AP Mode Blink rate at 5Hz
(Out of Phase with Activity LED)
Blink rate at 5Hz
(Out of Phase with Activity LED)
Task 5 GHz Activity LED (Amber) 2.4 GHz Activity LED (Green)
System Booting Solid On (During start up only) Solid On (During start up only)
Radio Shutdown
Administratively
or
LEDs Disabled
Off Off
Locate AP Mode Off Blinking
Firmware Upgrade Solid Off
Adopted (not configured) Solid Solid
Sensor Mode (Connected
to server)
Blink (On 1 second, Off 1 second) Blink (On 1 second, Off 1 second)
Sensor Mode (Not
connected to server)
Blink (On 1 second, Off 5
seconds)
Blink (On 1 second, Off 5
seconds)
Comentarios a estos manuales