Extreme Networks WM-4T1i Especificaciones descargar pdf (Pagina 155)

Extreme Networks Consolidated Hardware Guide 155

9 Alpine 3800 Series Switch Management

Module

This chapter describes:

• Installing SMMi Modules on page 157

• Removing SMMi Modules on page 159

NOTE

Read the information in this chapter thoroughly before you attempt to install or remove the Alpine Switch

Management Module (SMMi).

The Switch Management Module (SMMi) is responsible for upper-layer protocol processing and switch

management functions in the Alpine 3808 and Alpine 3804 chassis. The SMMi can store two

ExtremeWare software images (version 6.0 or later) and two switch configurations.

NOTE

The Alpine 3802 switch does not require a separate Switch Management Module. All upper-layer

protocol processing and switch management functions are part of the integrated Switch Management

Module that is located in the chassis.

Figure 70 shows the SMMi.

Figure 70: Switch Management Module (SMMi)

The SMMi module consists of a printed circuit board mounted on a metal panel that acts as the

insertion vehicle in an Alpine 3808 and Alpine 3804 chassis. The module carrier also includes

ejector/injector levers and captive retaining screws at each end of the module front panel.

The SMMi has the following out-of-band management ports:

• Console port—Used to connect a terminal and perform local management.

38_SMMi

Module status

LEDs

Module

reset button

Console

port

Modem

port

Management

port

PCMCIA slot

1 2 ... 150 151 152 153 154 155 156 157 158 159 160 ... 335 336

Sin comentarios

Extreme Networks WM-4T1i Especificaciones Pagina 155