Extreme Networks WM-4T1i Especificaciones descargar pdf (Pagina 161)

Extreme Networks Consolidated Hardware Guide 161

10 Alpine 3800 Series I/O Modules

This chapter describes:

• Configuring I/O Modules on page 161

• Installing I/O Modules on page 177

• Removing I/O Modules on page 179

NOTE

Read the information in this chapter thoroughly before you attempt to install or remove any Alpine I/O

modules.

Alpine I/O modules consist of a printed circuit board mounted on a metal panel that acts as the

insertion vehicle in an Alpine 3800 series switch. The module carrier also includes ejector/injector levers

and captive retaining screws at each end of the module front panel.

For more information about Alpine I/O module specifications, see Appendix C, “Module Technical

Specifications.”

Configuring I/O Modules

No configuration information is stored on the I/O modules; configuration information is stored on the

SMMi for the Alpine 3808 and 3804 chassis and the integrated Switch Management Module in the

Alpine 3802 chassis.

NOTE

There is a slight difference in appearance between Alpine I/O modules. Alpine Ethernet I/O modules

have a green stripe along the side of the module. Alpine Access I/O modules have a silver stripe along

the side of the module.

When the Alpine 3800 series switch is powered on, ExtremeWare generates a default configuration for

any slots with I/O modules. The default configuration allows the I/O module ports to participate in the

VLAN named default. The default configuration for the I/O module is not preserved unless you

explicitly save the information to nonvolatile RAM (NVRAM).

1 2 ... 156 157 158 159 160 161 162 163 164 165 166 ... 335 336

Sin comentarios

Extreme Networks WM-4T1i Especificaciones Pagina 161