Extreme Networks WM20 Controller Guía de usuario descargar pdf (Pagina 48)

Configuring the Summit WM Controller

Summit WM20 User Guide, Software Release 4.248

To set OSPF Routing Global Settings on the Summit WM Controller:

1 From the main menu, click Summit Switch Configuration. The Summit WM Controller

Configuration screen is displayed.

2 In the left pane, click Routing Protocols. The Static Routes tab is displayed.

3 Click the OSPF tab.

4 From the OSPF Status drop-down list, select ON to enable OSPF.

5 In the Router ID box, type the IP address of the Summit WM Controller. This ID must be unique

across the OSPF area. If left blank, the OSPF daemon automatically picks a router ID from one of the

Summit WM Controller’s interface IP addresses.

6 In the Area ID box, type the area. 0.0.0.0 is the main area in OSPF.

7 From the Area Type drop-down list, select one of the following:

● Default – The default acts as the backbone area (also known as area zero). It forms the core of an

OSPF network. All other areas are connected to it, and inter-area routing happens via a router

connected to the backbone area.

● Stub – The stub area does not receive external routes. External routes are defined as routes which

were distributed in OSPF via another routing protocol. Therefor, stub areas typically rely on a

default route to send traffic routes outside the present domain.

● Not-so-stubby – The not-so-stubby area is a type of stub area that can import autonomous

system (AS) external routes and send them to the default/backbone area, but cannot receive AS

external routes from the backbone or other areas.

8 To save your changes, click Save.

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 269 270

Sin comentarios

Extreme Networks WM20 Controller Guía de usuario Pagina 48