Extreme Networks e" series Guía de instalación Pagina 27

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 112
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 26
Evaluating and Meeting Cable Requirements
Consolidated "e" Series Hardware Installation Guide 27
Figure 1: Properly secured rack (SPG_007 redraw with e series in the rack)
Brace open distribution racks if the channel thickness is less than 1/4 inch (6.4 mm).
Evaluating and Meeting Cable Requirements
This section addresses requirements for the that cable you should use when installing your network
equipment. It includes:
Cabling Standards
Cable Labeling and Record Keeping
Installing Cable
RJ-45 Connector Jackets
Radio Frequency Interference
Cabling Standards
We recommend using the BICSI (Building Industry Consulting Service International) RCDD (Registered
Communications Distribution Designer), which is globally recognized as a standard in site planning and
cabling. For information, go to http://www.bicsi.org
SPG_00
7
Secure to floor
with 3/8 inch lag screws or bolts
Vista de pagina 26
1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 111 112

Comentarios a estos manuales

Sin comentarios