Extreme Networks e" series Guía de instalación Pagina 66

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 112
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 65
66 Consolidated "e" Series Hardware Installation Guide
“e” Switch Installation
Rack Mounting
CAUTION
Do not use the rack mount kits to suspend the switch from under a table or desk, or to attach the switch
to a wall.
To rack mount the Summit 200 series switch:
1 Place the switch upright on a hard flat surface, with the front facing you.
2 Remove the existing screws from the sides of the case (retain the screws for Step 4).
3 Locate a mounting bracket over the mounting holes on one side of the unit.
4 Insert the screws and fully tighten with a suitable screwdriver, as shown in Figure 17.
Figure 17: Fitting the mounting bracket
5 Repeat steps 2 through 4 for the other side of the switch.
6 Insert the switch into the 19-inch rack.
Take care to load the rack so that it is not top-heavy.
Do not cover vents that would restrict airflow. Leave a half-rack space between the units for
adequate ventilation. This space is especially important for Summit 400-48t switches that have the
optional ER XENPAK transceiver installed.
7 Secure the switch with suitable screws (not provided).
8 Connect the switch to the redundant power supply (if applicable).
9 Connect cables.
LC24003
LB48004
ES4K002
Vista de pagina 65
1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 111 112

Comentarios a estos manuales

Sin comentarios