Extreme Networks WM-4T1i Especificaciones Pagina 167

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 306
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 166
Extreme Networks Consolidated Hardware Guide 10-1
10
Alpine 3800 Series I/O Modules
This chapter describes:
Configuration information and specifications for the Alpine 3800 series I/O modules
Installation and removal procedures for the Alpine 3800 series I/O modules
Configuring I/O Modules
No configuration information is stored on the I/O modules; configuration information
is stored on the SMMi for the Alpine 3808 and 3804 chassis and the integrated Switch
Management Module in the Alpine 3802 chassis.
Note: There is a slight difference in appearance between Alpine Ethernet I/O
modules and Alpine Access I/O modules. Alpine Ethernet I/O modules have a
green stripe along the side of the module. Alpine Access I/O modules have a
silver stripe along the side of the module.
When the Alpine 3800 series switch is powered on, ExtremeWare generates a default
configuration for any slots with I/O modules. The default configuration allows the I/O
module ports to participate in the VLAN named default. The default configuration for
the I/O module is not preserved unless you explicitly save the information to
nonvolatile RAM (NVRAM).
You can configure parameters of the I/O module after it is installed or you can
pre-configure a slot for a certain type of module and configuration. The pre-configured
information is applied to the module after it is inserted. If you pre-configure a slot for a
Vista de pagina 166
1 2 ... 162 163 164 165 166 167 168 169 170 171 172 ... 305 306

Comentarios a estos manuales

Sin comentarios