
15-10 Extreme Networks Consolidated Hardware Guide
BlackDiamond 6800 Series Management Switch Module
To remove an MSM64i module:
1 Attach an ESD strap to your wrist and connect the metal end to the ground
receptacle that is located on the top-left corner of the switch front panel.
2 To loosen the module, unscrew the screws with a #1 Phillips screwdriver.
3 Simultaneously rotate the ejector/injector handles outward to disengage the module
from the backplane.
4 Slide the module out of the chassis.
5 If you are not going to install a replacement MSM64i, cover the slot with a blank
faceplate. Otherwise, follow the MSM64i module installation procedure on page 15-6.
6 Leave the ESD strap permanently connected to the chassis, so that it is always
available when you need to handle ESD-sensitive components.
Comentarios a estos manuales