Extreme Networks IP Service Manager Manual de usuario descargar pdf (Pagina 9)

Deployment Guide – ExtremeXOS, NetSight, NAC on BlackDiamond X8, BlackDiamond 8K, Summit Switches

2. Manage the configurations and images using the commands:

save configuration

use image primary

download image

unconfig switch all

3. Reboot the system by typing reboot.

Basic Forwarding

This section is meant to be a starting point and represents only a tiny subset of the functionality

and options within EXOS. Please refer to ExtremeXOS documentation on the Extreme

documentation page for full descriptions.

Data Ports

By default, all ports are enabled and in the “Default” VLAN in the “VR-Default” VR, without any

Layer 2 protocol to prevent loops.

1. Disable all ports and then enable only the used ports. For example:

disable ports all

enable ports 1-3,5,7

2. Configure per-port “display-string” that is displayed on each of the show port CLI

commands, or “description-string” to modify SNMP alias. For example:

configure ports 8 display-string foo-display-string

configure ports 8 description-string "foo-description-string"

3. Configure the port speed. For example:

configure ports 1 auto off speed 10000 duplex full

4. Configure LAG ports. For example:

enable sharing 7 grouping 7-12,14 algorithm address-based L2 lacp

enable sharing 49 grouping 49, 53 algorithm address-based L3_L4 lacp

5. Use the following show commands to view the ports status. To clear the counters in the

show commands below, issue the command clear counters.

show ports information

show ports configuration

show ports statistics

show port sharing

show l2stats

show port rxerrors

show port packet

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 34 35

Sin comentarios

Extreme Networks IP Service Manager Manual de usuario Pagina 9