Extreme Networks Summit WM Series Especificaciones descargar pdf (Pagina 52)

Physical ports configuration

HWC_GSG_PhysicalPortConfiguration..fm

Configuring data ports

120385-00 Rev 01, March 2007

52 Summit WM, Getting Started Guide

Enabling management provides access to the Summit Switch through the

selected port using SNMP (”get” only), SSH and HTTPS management

services.

7. To enable the SLP protocol, select the SLP checkbox.

Selecting the SLP checkbox will enable the Summit WM Switch to advertise

this port to the network for Altitude APs’ discovery.

8. Select either of the two VLAN options:

• Untagged: Select Untagged, if you are not using VLAN.

• Tagged: Select Tagged, and specify the VLAN ID in the VLANID text

box, if you are using VLAN.

Note: The VLAN text boxes on the Management Port Settings screen are displayed

only if you are using one of the following models:

• Summit Switch WM2000

• Summit Switch WM200

9. To allow multicast support, click Enabled from the drop-down list.

When you enable the multicast support, the interface is used for relaying

multicast traffic between core and wireless devices. You must define only one

port for the multicast traffic.

10. To save your changes, click Save.

11. Repeat Step 3 to Step 10 for every port that is to be enabled.

Now you must configure the routing on the Summit WM Switch. The following

chapter describes how to configure the Summit WM Switch’s physical ports.

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 139 140

Sin comentarios

Extreme Networks Summit WM Series Especificaciones Pagina 52