Extreme Networks Summit WM Series Especificaciones descargar pdf (Pagina 55)

HWC_GSG_RouterConfiguration.fm

Routing configuration

Configuring the OSPF routing

120385-00 Rev 01, March 2007

Summit WM, Getting Started Guide 55

2. Click Forwarding Table. The Forwarding Table is displayed.

3. To update the display, click Refresh.

5.2 Configuring the OSPF routing

To configure the OSPF routing, you must:

• Define one data port as a router port on the IP addresses screen.

• Enable OSPF globally on the Summit WM Switch. For more information, see

Section 5.2.1, “Enabling OSPF globally on the Summit WM Switch”, on page

56.

• Define the global OSPF parameters. For more information, see Section 5.2.2,

“Defining the global OSPF parameters”, on page 57.

Ensure that the OSPF parameters defined for the Summit WM Switch are

consistent with the adjacent routers in the OSPF area. The consistency

includes the following:

• Timer Settings – If the peer router has different timer settings, the protocol

timer settings in the Summit WM Switch must be changed to the peer

router to match in order to achieve OSPF adjacency.

• MTU – The MTU of the ports on either sides of the OSPF link must match.

You must remember here that the MTU for ports is set to 1500 on the

Summit WM Switch is when configuring the physical data ports on IP

addresses’ screen. The value of 1500 matches the MTU in standard

routers.

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 139 140

Sin comentarios

Extreme Networks Summit WM Series Especificaciones Pagina 55