Extreme Networks Summit WM Series Especificaciones descargar pdf (Pagina 93)

HWC_GSG_APConfiguration.fm

Altitude AP’s configuration

Altitude AP’s LED states

120385-00 Rev 01, March 2007

Summit WM, Getting Started Guide 93

7.7 Altitude AP’s LED states

When the Altitude AP is powered on and boots, you can follow its progress

through the registration process by observing the LED sequence described

below.

The Status LED (center) also indicates power — unlit when unit is off, and green

(solid) when the Altitude AP has completed discovery and is operational.

Figure 12 Altitude AP LEDs

Left LED Status Center LED Status Right LED

Status

Altitude AP Status

Off Off Off Powered-off

Off Green Off Beginning of Power-on-Self-Test (POST) (0.5 seconds)

Off Off Off Power-on-Self-Test (POST

Off Red Off Failure during POST

Green Off Green Random delay – State displayed only after a vulnerable reset

Green/Off Off/Green Green/Off Vulnerable time interval – The Altitude AP resets to factory

default if powered-off for three consecutive times during this

state. No vulnerable period when Altitude AP is resetting to

factory defaults.

Green/Off/Off Off/Green/Off Off/Off/Green Resetting to factory defaults announcement – replaces

vulnerable period. This pattern is repeated twice to notify the

operator when the factory configuration is restored.

Off Orange

(Green + Red)

Off Attempting to obtain an IP address via DHCP.

Off Red/Orange Off No DHCP reply has been received.

Off Green/Orange Off Failed discovery (SLP)

Off Off/Orange Off Summit WM Switch has been discovered. Registering the

Altitude AP.

Off Off/Red Off Registration of the Altitude AP has failed.

Off Off/Green Off Standby, registered with a Summit WM Switch, waiting for

configuration.

Table 5 Altitude AP LED status

1 2 ... 88 89 90 91 92 93 94 95 96 97 98 ... 139 140

Sin comentarios

Extreme Networks Summit WM Series Especificaciones Pagina 93