Extreme Networks ExtremeWare XOS Command Especificaciones descargar pdf (Pagina 701)

100

101

configure pim register-rate-limit-interval

ExtremeWare XOS 10.1 Command Reference Guide 701

configure pim register-rate-limit-interval

configure pim register-rate-limit-interval <interval>

Description

Configures the initial PIM-SM periodic register rate.

Syntax Description

Default

Default is 0.

Usage Guidelines

Configuring a non-zero interval time can reduce the CPU load on the first hop switch, in case register

stop messages are not received normally.

When a non-zero value is configured, the first hop switch sends a few register messages and then waits

for a corresponding register stop from RP for <

time> seconds. The process is repeated until the register

stop is received.

The default value is zero in default mode, the switch sends continuous register messages until the

Example

The following command configures the initial PIM register rate limit interval:

configure pim register-rate-limit-interval 2

interval Specifies an interval time in seconds. Range is 0 - 60. Default is 0.

1 2 ... 696 697 698 699 700 701 702 703 704 705 706 ... 757 758

Comentarios a estos manuales

Sin comentarios

Extreme Networks ExtremeWare XOS Command Especificaciones Pagina 701

Comentarios a estos manuales