Extreme Networks Summit WM Series Guía de usuario descargar pdf (Pagina 119)

Summit WM-Series WLAN Switch and Altitude Access Point Software Version 1.0 User Guide

119

9 Setting up third-party access points

Your enterprise's WLAN may have existing third-party access points that you would like to integrate

into the Summit WM-Series Switch Software WLAN solution. You can set up the Summit WM-Series

Switch to handle wireless device traffic from third-party access points, providing the same policy and

network access control.

Set up third-party access points on the Summit WM-Series Switch

1 Define one data port as a “3rd-party AP” port:

In the Summit WM-Series Switch Configuration screen, click on the IP Address option. The

Management Port Settings and Interfaces screen appears. Highlight the appropriate port, and in the

Function field, select “3rd-party AP” from the drop-down list. Make sure that Management Traffic

and SLP are disabled for this port.

2 Connect the third-party access point to this port, via a switch.

3 Define a static route to the access point:

In the Summit WM-Series Switch Configuration screen, click on the Routing Protocols option. Then

click the Static Routes tab. The Static Routes screen appears. Define a static route to the access point

(see “Setting up static routes” on page 35).

1 2 ... 114 115 116 117 118 119 120 121 122 123 124 ... 227 228

Sin comentarios

Extreme Networks Summit WM Series Guía de usuario Pagina 119