Extreme Networks Summit WM Series Guía de usuario Pagina 177
- Pagina / 228
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
Summit WM-Series WLAN Switch and Altitude Access Point Software Version 1.0 User Guide
177
D Reference lists of standards
RFC list
Listed below are the Internet Engineering Task Force (IETF) Request for Comments (RFCs) standards
supported by Summit WM-Series Switch Software.
The Request for Comments, a series of notes about the Internet, submitted to the Internet Engineering
Task Force (IETF) and designated by an RFC number, that may evolve into an Internet standard. The
RFCs are catalogued and maintained on the IETF RFC website: www.ietf.org/rfc.html.
Table 8: List of RFCs
RFC Number Title
RFC 791 IPv4
RFC 1812 Minimum Router Requirements
RFC 793 Transport Control Protocol (TCP)
RFC 768 User Datagram Protocol (UDP)
RFC 792 Internet Control Message Protocol (ICMP)
RFC 826 Address Resolution Protocol (ARP)
RFC 2865 Remote Access Dial In User Service (RADIUS)
RFC 2866 RADIUS Accounting
RFC 2165, 2608 Service Location Protocol (SLP)
RFC 2131 Dynamic Host Configuration Protocol (DHCP)
RFC 2328 Open Shortest Path First (OSPF v2)
RFC 1587 OSPF Not So Stubby Area (NSSA) Option
RFC1350: The TFTP Protocol (Revision 2)
RFC 2716 EAP-TLS
RFC 1155 Structure and identification of management information for TCP/IP-based internets.
RFC 1157 Simple Network Management Protocol (SNMP).
RFC 1212 Concise MIB definitions.
RFC 1213 Management Information Base for Network Management of TCP/IP-based internets
MIB-II.
RFC 1215 Convention for defining traps for use with the SNMP.
RFC 1901 Introduction to Community-based SNMPv2 (SNMPv2c).
RFC 2011 SNMPv2 Management Information Base for the Internet Protocol using SMIv2.
RFC 2012 SNMPv2 Management Information Base for the Transmission Control Protocol using
SMIv2.
RFC 2013 SNMPv2 Management Information Base for the User Datagram Protocol using
SMIv2.
RFC 2578 Structure of Management Information Version 2 (SMIv2).
RFC 2579 Textual Conventions for SMIv2. 2580 Conformance Statements for SMIv2.
RFC 2863 The Interfaces Group MIB.
- Table of Contents 3
- Formatting conventions 10
- Documentation feedback 10
- Protocols and standards 11
- Regulatory information 11
- About this Guide 12
- Conventional wireless LANS 13
- Wireless AP 15
- Summit WM 15
- Wireless Controller 15
- Network traffic flow 18
- Network security 19
- Policy: packet filtering 21
- Mobility and roaming 21
- Availability 22
- Quality of Service (QoS) 22
- Data ports (4 or 2) 24
- Management ports 24
- Configuration steps: overview 31
- Enabling the product key 31
- Setting up the data ports 32
- Port Type or Function 34
- Setting up static routes 35
- Setting up OSPF Routing 36
- Define port exception filters 40
- 4 Altitude AP: startup 41
- Installing the Altitude APs 43
- Set the discovery timers 45
- Discovery and registration 46
- Registration after discovery 48
- Altitude AP access approval 49
- ● 802.11 b/g (2.4 GHz radio) 53
- ● 802.11a (5 GHz radio) 53
- Adding a Altitude AP manually 56
- Auto Cell software 58
- Configure Auto Cell software 59
- Altitude AP: startup 60
- Introduction 61
- What is a WM-AD? 62
- Topology of a WM-AD 62
- Filtering for a WM-AD 64
- Setting up a new WM-AD 66
- Global Settings for a WM-AD 68
- Topology for a WM-AD 71
- Use DHCP Relay for the WM-AD 74
- Topology for a WM-AD for AAA 75
- Authentication for a WM-AD 76
- ● No Captive Portal Support 80
- Captive Portal” on page 87) 81
- Accounting for a WM-AD 84
- RADIUS Policy for a WM-AD 84
- Filtering rules for a WM-AD 86
- Default Filter: Examples 93
- Multicast for a WM-AD 95
- Privacy for a WM-AD 96
- Privacy for a WM-AD for AAA 97
- A WM-AD for voice traffic 101
- Availability and Mobility 103
- Management users 111
- Network time 112
- Check Point event logging 113
- Setting up SNMP 115
- Setting SNMP Parameters 116
- Overview 123
- Summit Spy: running scans 125
- The Analysis Engine 126
- 11 Ongoing operation 131
- Altitude AP client management 133
- Client disassociate 134
- Client blacklist 135
- Health Checking 136
- Change the system log level 136
- Enable and configure Syslog 136
- Logs and alarms 141
- View the Logs 142
- View the Traces 142
- View the Audits 143
- Reports and displays 144
- View reports 146
- Glossary 147
- D (Continued) 149
- F (Continued) 151
- H (Continued) 152
- I (Continued) 153
- O (Continued) 156
- P (Continued) 157
- S (Continued) 160
- T (Continued) 162
- W (Continued) 164
- Altitude AP system states 168
- B CLI command reference 169
- CLI command reference 170
- RFC list 177
- 802.11 standards list 178
- Reference lists of standards 180
- E Support for Altitude AP 181
- F RADIUS Attributes 183
- RADIUS Accounting 184
- Account-Stop/Interim Packet 185
- Termination Codes 186
- G Logs and Events 187
- Logs and Events 188
- Critical 189
- CDR_COLLECTOR 191
- CONFIG_MANAGER 191
- EVENT_SERVER 192
- RADIUS_ACCOUNTING 194
- RADIUS_CLIENT 194
- RF_DATA_COLLECTOR 195
- RU_MANAGER 195
- SECURITY_MANAGER 196
- STARTUP_MANAGER 197
- STATS_SERVER 198
- ACCESSPOINT 200
- CPDP_AGENT_ID 203
- NSM_SERVER 205
- OSPF_SERVER 206
- PORT_INFO_J_MANAGER 206
- REDIR_ID 207
- H Regulatory Information 213
- Emissions 214
- FCC ID#: RJF-A3502 216
- Part 15 Unlicensed Antenna 217
- European Community 218
- European Spectrum Usage Rules 221
- Regulatory Information 222
- Declarations of Conformity 223
Relacionado con productos y manuales para Software Extreme Networks Summit WM Series
(7 paginas)
© 2020, manymanuals.es. Todos los derechos reservados | 0.034 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales