Extreme Networks Summit WM Series Guía de usuario Pagina 220
- Pagina / 228
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
Regulatory Information
Summit WM-Series WLAN Switch and Altitude Access Point Software Version 1.0 User Guide
220
● The Altitude 350-2 wireless port requires the end user or installer to properly enter the correct
country code into the switch software prior to operating the Altitude 350-2, to allow for proper
configuration in conformance with European National spectrum usage laws.
● After the first Altitude 350-2 wireless port is connected to the switch, each additional wireless port
connected will inherit the operating configuration of the first Altitude 350-2 wireless port. The user
or installer is responsible to ensure the first Altitude 350-2 wireless port is properly configured.
● The software within the switch will automatically limit the allowable channels and output power
determined by the current country code entered. Incorrectly entering the country of operation or
identifying the proper antenna used, may result in illegal operation and may cause harmful
interference to other systems.
● This device employs a radar detection feature required for European Community operation in the 5
GHz band. This feature is automatically enabled when the country of operation is correctly
configured for any European Community country. The presence of nearby radar operation may
result in temporary interruption of operation of this device. The radar detection feature will
automatically restart operation on a channel free of radar.
● The 5 GHz Turbo Mode feature is not enabled for use on the Altitude 350-2 Model 15938 and 15939
access point.
● The AutoChannelSelect/SmartSelect setting of the 5 GHz described in the switch software guide
must always remain enabled to ensure that automatic 5 GHz channel selection complies with
European requirements. The current setting for this feature is found in the 5 GHz Radio
Configuration Window as described in this switch software manual.
● The Altitude 350-2 with integral or detachable antennas may be used to transmit indoors and
outdoors in countries of the European Community, as indicated in Table 14.
Go to http://www.extremenetworks.com/go/rfcertification.htm for the most up to date limitation
and restrictions.
● The Altitude 350-2 must be operated indoors only when using the 5150- 5350 MHz bands, channels
36, 40, 44, 48, 52, 56, 60, or 64. See Table 13 for permitted 5 GHz channels by country.
● The Altitude 350-2 with detachable antenna must be used only with antennas certified by Extreme
Networks.
● The Altitude 350-2 may be operated indoors or outdoors in all countries of the European
Community using the 2.4 GHz band: Channels 1 – 13, except where noted in Table 14.
● In Italy, the end user must apply for a license from the national spectrum authority to operate this
device outdoors.
● In Belgium, outdoor operation is only permitted using the 2.46 - 2.4835 GHz band: Channel 13.
● In France, outdoor operation is only permitted using the 2.4 - 2.454 GHz band: Channels 1 - 7.
- Table of Contents 3
- Formatting conventions 10
- Documentation feedback 10
- Protocols and standards 11
- Regulatory information 11
- About this Guide 12
- Conventional wireless LANS 13
- Wireless AP 15
- Summit WM 15
- Wireless Controller 15
- Network traffic flow 18
- Network security 19
- Policy: packet filtering 21
- Mobility and roaming 21
- Availability 22
- Quality of Service (QoS) 22
- Data ports (4 or 2) 24
- Management ports 24
- Configuration steps: overview 31
- Enabling the product key 31
- Setting up the data ports 32
- Port Type or Function 34
- Setting up static routes 35
- Setting up OSPF Routing 36
- Define port exception filters 40
- 4 Altitude AP: startup 41
- Installing the Altitude APs 43
- Set the discovery timers 45
- Discovery and registration 46
- Registration after discovery 48
- Altitude AP access approval 49
- ● 802.11 b/g (2.4 GHz radio) 53
- ● 802.11a (5 GHz radio) 53
- Adding a Altitude AP manually 56
- Auto Cell software 58
- Configure Auto Cell software 59
- Altitude AP: startup 60
- Introduction 61
- What is a WM-AD? 62
- Topology of a WM-AD 62
- Filtering for a WM-AD 64
- Setting up a new WM-AD 66
- Global Settings for a WM-AD 68
- Topology for a WM-AD 71
- Use DHCP Relay for the WM-AD 74
- Topology for a WM-AD for AAA 75
- Authentication for a WM-AD 76
- ● No Captive Portal Support 80
- Captive Portal” on page 87) 81
- Accounting for a WM-AD 84
- RADIUS Policy for a WM-AD 84
- Filtering rules for a WM-AD 86
- Default Filter: Examples 93
- Multicast for a WM-AD 95
- Privacy for a WM-AD 96
- Privacy for a WM-AD for AAA 97
- A WM-AD for voice traffic 101
- Availability and Mobility 103
- Management users 111
- Network time 112
- Check Point event logging 113
- Setting up SNMP 115
- Setting SNMP Parameters 116
- Overview 123
- Summit Spy: running scans 125
- The Analysis Engine 126
- 11 Ongoing operation 131
- Altitude AP client management 133
- Client disassociate 134
- Client blacklist 135
- Health Checking 136
- Change the system log level 136
- Enable and configure Syslog 136
- Logs and alarms 141
- View the Logs 142
- View the Traces 142
- View the Audits 143
- Reports and displays 144
- View reports 146
- Glossary 147
- D (Continued) 149
- F (Continued) 151
- H (Continued) 152
- I (Continued) 153
- O (Continued) 156
- P (Continued) 157
- S (Continued) 160
- T (Continued) 162
- W (Continued) 164
- Altitude AP system states 168
- B CLI command reference 169
- CLI command reference 170
- RFC list 177
- 802.11 standards list 178
- Reference lists of standards 180
- E Support for Altitude AP 181
- F RADIUS Attributes 183
- RADIUS Accounting 184
- Account-Stop/Interim Packet 185
- Termination Codes 186
- G Logs and Events 187
- Logs and Events 188
- Critical 189
- CDR_COLLECTOR 191
- CONFIG_MANAGER 191
- EVENT_SERVER 192
- RADIUS_ACCOUNTING 194
- RADIUS_CLIENT 194
- RF_DATA_COLLECTOR 195
- RU_MANAGER 195
- SECURITY_MANAGER 196
- STARTUP_MANAGER 197
- STATS_SERVER 198
- ACCESSPOINT 200
- CPDP_AGENT_ID 203
- NSM_SERVER 205
- OSPF_SERVER 206
- PORT_INFO_J_MANAGER 206
- REDIR_ID 207
- H Regulatory Information 213
- Emissions 214
- FCC ID#: RJF-A3502 216
- Part 15 Unlicensed Antenna 217
- European Community 218
- European Spectrum Usage Rules 221
- Regulatory Information 222
- Declarations of Conformity 223
Relacionado con productos y manuales para Software Extreme Networks Summit WM Series
(7 paginas)
© 2020, manymanuals.es. Todos los derechos reservados | 0.081 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales