Extreme Networks Summit WM Series Guía de usuario descargar pdf (Pagina 36)

Summit WM-Series Switch Software configuration

Summit WM-Series WLAN Switch and Altitude Access Point Software Version 1.0 User Guide

7 The Override dynamic routes checkbox is on by default. This means the static routes defined here

will have priority over the OSPF learned routes (including default route) that the Summit WM-Series

Switch uses for routing. If you wish to remove this priority for static routes, so that routing is

controlled dynamically at all times, click the Override dynamic routes checkbox off.

NOTE

If you enable dynamic routing (OSPF), the dynamic routes will normally have priority for outgoing routing. For

internal routing on the Summit WM-Series Switch, the static routes normally have priority.

8 Click on Save to update the routing table on the Summit WM-Series Switch.

Viewing the Routing Table on the Summit WM-Series Switch

To view the static routes that have been defined for the Summit WM-Series Switch, click on the View

Forwarding Table tab. This displays the Forwarding Table also accessed in the Reports & Displays area

of the user interface.

This report displays all defined routes, whether static or OSPF, and their current status. To update the

display, click on the Refresh button.

Setting up OSPF Routing

To enable OSPF routing, you must first define one data port as a “Router Port” in the IP Addresses

screen. Next, enable OSPF globally on the Summit WM-Series Switch, and define the global OSPF

parameters. Then you enable (or disable) OSPF on the port that you defined as a “Router Port”.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 227 228

Sin comentarios

Extreme Networks Summit WM Series Guía de usuario Pagina 36