Extreme Networks Summit WM Series Guía de usuario Pagina 192
- Pagina / 228
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
Logs and Events
Summit WM-Series WLAN Switch and Altitude Access Point Software Version 1.0 User Guide
192
EVENT_SERVER
CONFIG_MANAGER
Severity Critical
Log Message Access point controlled software upgrade has failed. This normally occurs if a corrupt image
file was selected as the upgrade image. Please select another image for the upgrade: %s
Description AP upgrade has failed due to a bad software image.
Action The selected upgrade image has a problem. Select a known good image and apply it to the
access points for upgrade. Normally, this error results from the original image having been
obtained via FTP without the "bin" directive.
CONFIG_MANAGER
Severity Critical
Log Message Access point automatic software upgrade/downgrade has failed. This normally occurs if a
corrupt image file was selected as the default image. Please select another default image.
This alarm will repeat as long as the system is in automatic mode: %s
Description Automatic AP upgrade request has failed due to a bad software image.
Action The selected upgrade image has a problem. Select a known good image and apply it to the
access points for upgrade. Normally, this error results from the original image having been
obtained via FTP without the "bin" directive.
EVENT_SERVER
Severity Critical
Log Message Cannot access logging file. Unable to save any system log messages.
Description Unable to open log files for message storage.
Action Indicates a low level file system problem, or the file permissions may have been altered.
Check the file permissions first. If they appear to be correct, the file system may be
corrupted. Log messages should still be forwarded to syslog and SNMP if services are
enabled.
EVENT_SERVER
Severity Critical
Log Message Critical internal error - log file protection flags have been corrupted. Event server will halt.
Description File system has encountered a problem and the log file cannot be opened for writing.
Action Indicates that the logging partition is corrupted. Contact service as the controller may
require servicing.
EVENT_SERVER
Severity Critical
Log Message Internal system interrupt handlers failed to initialize. Event server will halt.
Description Internal service failure.
Action In normal operating circumstances, the entire system behaves erratically, if functioning at
all. Contact service s the system may require servicing.
- Table of Contents 3
- Formatting conventions 10
- Documentation feedback 10
- Protocols and standards 11
- Regulatory information 11
- About this Guide 12
- Conventional wireless LANS 13
- Wireless AP 15
- Summit WM 15
- Wireless Controller 15
- Network traffic flow 18
- Network security 19
- Policy: packet filtering 21
- Mobility and roaming 21
- Availability 22
- Quality of Service (QoS) 22
- Data ports (4 or 2) 24
- Management ports 24
- Configuration steps: overview 31
- Enabling the product key 31
- Setting up the data ports 32
- Port Type or Function 34
- Setting up static routes 35
- Setting up OSPF Routing 36
- Define port exception filters 40
- 4 Altitude AP: startup 41
- Installing the Altitude APs 43
- Set the discovery timers 45
- Discovery and registration 46
- Registration after discovery 48
- Altitude AP access approval 49
- ● 802.11 b/g (2.4 GHz radio) 53
- ● 802.11a (5 GHz radio) 53
- Adding a Altitude AP manually 56
- Auto Cell software 58
- Configure Auto Cell software 59
- Altitude AP: startup 60
- Introduction 61
- What is a WM-AD? 62
- Topology of a WM-AD 62
- Filtering for a WM-AD 64
- Setting up a new WM-AD 66
- Global Settings for a WM-AD 68
- Topology for a WM-AD 71
- Use DHCP Relay for the WM-AD 74
- Topology for a WM-AD for AAA 75
- Authentication for a WM-AD 76
- ● No Captive Portal Support 80
- Captive Portal” on page 87) 81
- Accounting for a WM-AD 84
- RADIUS Policy for a WM-AD 84
- Filtering rules for a WM-AD 86
- Default Filter: Examples 93
- Multicast for a WM-AD 95
- Privacy for a WM-AD 96
- Privacy for a WM-AD for AAA 97
- A WM-AD for voice traffic 101
- Availability and Mobility 103
- Management users 111
- Network time 112
- Check Point event logging 113
- Setting up SNMP 115
- Setting SNMP Parameters 116
- Overview 123
- Summit Spy: running scans 125
- The Analysis Engine 126
- 11 Ongoing operation 131
- Altitude AP client management 133
- Client disassociate 134
- Client blacklist 135
- Health Checking 136
- Change the system log level 136
- Enable and configure Syslog 136
- Logs and alarms 141
- View the Logs 142
- View the Traces 142
- View the Audits 143
- Reports and displays 144
- View reports 146
- Glossary 147
- D (Continued) 149
- F (Continued) 151
- H (Continued) 152
- I (Continued) 153
- O (Continued) 156
- P (Continued) 157
- S (Continued) 160
- T (Continued) 162
- W (Continued) 164
- Altitude AP system states 168
- B CLI command reference 169
- CLI command reference 170
- RFC list 177
- 802.11 standards list 178
- Reference lists of standards 180
- E Support for Altitude AP 181
- F RADIUS Attributes 183
- RADIUS Accounting 184
- Account-Stop/Interim Packet 185
- Termination Codes 186
- G Logs and Events 187
- Logs and Events 188
- Critical 189
- CDR_COLLECTOR 191
- CONFIG_MANAGER 191
- EVENT_SERVER 192
- RADIUS_ACCOUNTING 194
- RADIUS_CLIENT 194
- RF_DATA_COLLECTOR 195
- RU_MANAGER 195
- SECURITY_MANAGER 196
- STARTUP_MANAGER 197
- STATS_SERVER 198
- ACCESSPOINT 200
- CPDP_AGENT_ID 203
- NSM_SERVER 205
- OSPF_SERVER 206
- PORT_INFO_J_MANAGER 206
- REDIR_ID 207
- H Regulatory Information 213
- Emissions 214
- FCC ID#: RJF-A3502 216
- Part 15 Unlicensed Antenna 217
- European Community 218
- European Spectrum Usage Rules 221
- Regulatory Information 222
- Declarations of Conformity 223
Relacionado con productos y manuales para Software Extreme Networks Summit WM Series
(7 paginas)
© 2020, manymanuals.es. Todos los derechos reservados | 0.040 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales