Extreme Networks Summit WM Series Guía de usuario descargar pdf (Pagina 45)

Performing the first-time setup of the Summit WM series switch

Summit WM Series WLAN Switch and Altitude Access Point Software Version 4.1 User Guide

4 Type the following:

● IP address – The IP Address of the physical Ethernet port.

● Subnet mask – The appropriate subnet mask for the IP address, which separates the network

portion from the host portion of the address (typically 255.255.255.0).

● MTU – The Maximum Transmission Unit or maximum packet size for this port. The default

setting is 1500. If you change this setting and are using OSPF, be sure that the MTU of each port

in the OSPF link matches.

NOTE

If the routed connection to an AP traverses a link that imposes a lower MTU than the default 1500 bytes, the

Summit WM series switch and AP both participate in MTU discovery to automatically learn the correct MTU and

adjust their settings accordingly. At the Summit WM series switch, MTU adjustments are tracked on a per AP

basis.

5 Select a Function from the drop-down list:

● Host Port – Specifies a port for connecting Altitude APs with no dynamic routing.

● Third-Party AP Port – Specifies a port to which you will connect third-party access points.

● Router Port – Specifies a port that you want to connect to an upstream, next-hop router in the

network.

NOTE

For OSPF routing on a port, the port must be configured as a router port.

6 To enable management traffic, select the Mgmt checkbox. Enabling management provides access to

SNMP (v2, get), SSH, and HTTPs management interfaces.

NOTE

This option does not override the built-in protection filters on the port. The built-in protection filters for the port,

which are restrictive in the types of packets that are allowed to reach the management plane, are extended with

a set of definitions that allow for access to system management services through that interface (SSH, SNMP,

HTTPS:5825).

7 To enable the SLP protocol, select the SLP checkbox.

Altitude APs use this port for discovery and registration. Other controllers can use this port to

enable inter-controller device mobility if this port is configured to use SLP or the Summit WM series

switch is running as a manager and SLP is the discovery protocol used by the agents.

8 To allow Multicast Support, select Enabled from the drop-down list.

9 To save your changes, click Save.

Setting up static routes

It is recommended that you define a default route to your enterprise network, either with a static route

or by using OSPF protocol. A default route enables the Summit WM series switch to forward packets to

destinations that do not match a more specific route definition.

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 267 268

Sin comentarios

Extreme Networks Summit WM Series Guía de usuario Pagina 45