Extreme Networks Summit WM Series Guía de usuario descargar pdf (Pagina 69)

Modifying Altitude AP settings

Summit WM Series WLAN Switch and Altitude Access Point Software Version 4.1 User Guide

To modify an Altitude AP’s properties:

1 From the main menu, click Altitude AP Configuration. The Altitude AP screen is displayed.

2 In the Altitude AP list, click the Altitude AP whose properties you want to modify. The AP

Properties tab displays Altitude AP information.

3 Modify the Altitude AP’s information:

● Name – Type a unique name for the Altitude AP that identifies the AP. The default value is the

Altitude AP’s serial number.

● Description – Type comments for the Altitude AP.

● Port # – Select the Ethernet port of the switch the Altitude AP is connected to.

● Poll Timeout – Type the timeout value, in seconds, for polling the controller. The default value is

10 seconds.

● Poll Interval – Type the interval value, in seconds, for polling the controller. The default value is

2 seconds.

● Telnet Access – Select whether Telnet Access to the Altitude AP is enabled or disabled.

● Maintain client session in event of poll failure – Select this option if the AP should remain

active if a link loss with the controller occurs.This option is enabled by default.

● Use broadcast for disassociation – Select if you want the Altitude AP to use broadcast

disassociation when disconnecting all clients, instead of disassociating each client one by one.

This will affect the behavior of the AP under the following conditions:

■ If the Altitude AP is preparing to reboot or to enter one of the special modes (DRM initial

channel selection).

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 267 268

Sin comentarios

Extreme Networks Summit WM Series Guía de usuario Pagina 69