Extreme Networks BlackDiamond 10808 Guía de instalación descargar pdf (Pagina 16)

16 Extreme Networks BlackDiamond 10K-Series Switch Installation Guide

BlackDiamond 10808 Switch Overview

To remove a mini-GBIC connector similar to the one labeled “Module B” in Figure 1, gently rotate the

front handle and pull the mini-GBIC out of the SFP receptacle.

To insert a mini-GBIC connector:

NOTE

Mini-GBICs can be installed in the SFP mini-GBIC receptacles only.

1 Holding the mini-GBIC by its sides, insert the mini-GBIC into the SFP receptacle on the switch or

module.

2 Slide the mini-GBIC into the SFP receptacle until you hear an audible click, indicating the mini-GBIC

is securely seated into the SFP receptacle. If the mini-GBIC has a handle, push up on the handle to

secure the mini-GBIC.

XENPAK Module Installation

This section describes installing and removing the XENPAK module, a 10 Gbps optical transceiver. You

can install or remove the XENPAK module from your Extreme Networks switch without powering off

the system. The module is shown in Figure 2.

Figure 2: XENPAK module

The XENPAK module is a Class 1 laser device. Use only Extreme-approved devices on all Extreme

switches.

CAUTION

The XENPAK module can emit invisible laser radiation. Avoid direct eye exposure to beam.

WARNING!

To prevent ESD damage to the XENPAK module, always use an appropriately grounded ESD-preventive

wrist strap when installing or removing the module. Handle the module by its sides only. Never touch the

card-edge connectors at the insertion end of the module.

EWUG003B

Card edge

connector

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 87 88

Sin comentarios

Extreme Networks BlackDiamond 10808 Guía de instalación Pagina 16