Extreme Networks BlackDiamond 10808 Guía de instalación descargar pdf (Pagina 48)

48 Extreme Networks BlackDiamond 10K-Series Switch Installation Guide

BlackDiamond 10808 Switch Management Module

Installing MSMs

The BlackDiamond MSM is hot-swappable. You do not need to power off the system to insert an MSM.

You need the following tools and equipment to install an MSM:

• ESD-preventive wrist strap

• # 1 Phillips screwdriver

• MSM module

To install the MSM:

1 Select a slot for the module:

• Slot A or slot B in the BlackDiamond 10808 switch

CAUTION

You can install MSMs in lettered slots only. MSMs do not fit in numbered slots. Forceful insertion can

damage the MSM.

2 Attach the ESD strap that is provided to your wrist and connect the metal end to the ground

receptacle that is located on the top-left corner of the switch front panel.

3 Remove the blank faceplate from the slot to make room for the module, if applicable.

NOTE

Any unoccupied module slot in the chassis should have a blank faceplate installed to ensure

satisfactory protection from EMI and to guarantee adequate airflow through the chassis.

4 Place the ESD bag containing the MSM on a flat ESD surface, clean from any debris.

5 Break any seals on the bag.

6 Open the ESD bag and firmly grasp the rail of the module.

7 Holding the rail of the module, pull the ESD bag off the module.

NOTE

By holding the rail of the module and pulling the ESD module off the module, you will prevent

damage to the module that might be caused by sliding the module on the ESD surface.

8 Check the connectors for dust and packing materials.

CAUTION

To prevent ESD damage, handle the module by the metal panel edges only. Never touch the

components on the PCB or pins on any of the connectors.

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 87 88

Sin comentarios

Extreme Networks BlackDiamond 10808 Guía de instalación Pagina 48