Extreme Networks BlackDiamond 10808 Guía de instalación descargar pdf (Pagina 80)

80 Extreme Networks BlackDiamond 10K-Series Switch Installation Guide

Safety Information

• This unit operates under Safety Extra Low Voltage (SELV) conditions according to the IEC 950

standard. The conditions are only maintained if the equipment to which it is connected also operates

under SELV conditions.

• The appliance coupler (the connector to the unit and not the wall plug) must have a configuration

for mating with an EN60320/IEC320 appliance inlet.

• France and Peru only

This unit cannot be powered from IT† supplies. If your supplies are of IT type, this unit must be

labeled Neutral and connected directly to ground.

Power Cable

Use an AC power cable appropriate for your country. Check your local electrical codes and regulatory

agencies for power cable requirements. The countries listed below have the following additional

requirements:

• USA and Canada

— The cable set must be UL-listed and CSA-certified.

— The minimum specification for the flexible cable is No. 18 AWG (1.5 mm

), Type SVT or SJT,

3-conductor.

— The cable set must have a rated current capacity of at least the amount rated for each specific

product.

— The AC attachment plug must be an Earth-grounding type with a NEMA 5-15P (10 A, 125 V)

configuration.

• Denmark

— The supply plug must comply with section 107-2-D1, standard DK2-1a or DK2-5a.

• Switzerland

— The supply plug must comply with SEV/ASE 1011.

• Argentina

— The supply plug must comply with Argentinian standards.

NOTE

When using dual power supplies, make sure that each AC power supply attaches to an independent

power source.

1 2 ... 75 76 77 78 79 80 81 82 83 84 85 86 87 88

Sin comentarios

Extreme Networks BlackDiamond 10808 Guía de instalación Pagina 80