Extreme Networks BlackDiamond 10808 Guía de instalación Pagina 57

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 88
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 56
I/O Module LEDs
Extreme Networks BlackDiamond 10K-Series Switch Installation Guide 57
If you have one MSM module installed, all ports on the 10G6X module are switched through that MSM
module. If you have two MSM modules installed, the top 3 ports on the 10G6X module are switched
through the MSM module in slot A, and the bottom 3 ports are switched through the MSM module in
slot B during normal operation.
The default configuration of the 10G6X module is as follows.
All ports:
• Are added to the default VLAN as untagged.
• Inherit the properties of the default VLAN (protocol type, VLANid, and so forth).
If you have one MSM module installed, all ports are switched through that MSM module. If you have
two MSM modules installed, the top three ports on the 10G6X module are switched through the MSM
module in slot A, and the bottom three ports are switched through the MSM module in slot B during
normal operation.
LEDs
The 10G6X module has the following LEDs:
Module status
Port status
For information about the LEDs and their activity on the 10G6X module, see “I/O Module LEDs” on
page 57.
I/O Module LEDs
Table 13 describes the LED activity on the BlackDiamond I/O modules.
Table 13: BlackDiamond Ethernet I/O module LEDs
LED Color Indicates
Status Green blinking
Amber blinking
Off
Normal operation
Configuration error, code version error, diagnostic failure, or other
severe module error
No power
DIAG Off
Amber blinking
Amber
Normal operation
Diagnostics in progress
Diagnostic failure
Port x Green
Green blinking
Amber blinking
Off
Link up
Link down
Packet activity
Link down
Vista de pagina 56
1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 87 88

Comentarios a estos manuales

Sin comentarios