Extreme Networks BlackDiamond 10808 Guía de instalación descargar pdf (Pagina 58)

58 Extreme Networks BlackDiamond 10K-Series Switch Installation Guide

BlackDiamond 10808 I/O Modules

Installing I/O Modules

You can insert I/O modules at any time, without causing disruption of network services. Complete the

action of inserting a BlackDiamond I/O module in a reasonable time frame. Be sure to insert the

module completely to avoid partial connection of backplane connectors.

You need the following tools and equipment to install an I/O module:

• ESD-preventive wrist strap

• # 1 Phillips screwdriver

• I/O module

• Appropriate type of cable for the I/O module you plan to install

To install an I/O module:

1 Select a slot for the module. Slots are numbered 1 through 8 in the BlackDiamond 10808 chassis.

2 Attach the ESD strap that is provided to your wrist and connect the metal end to the ground

receptacle that is located on the top-left corner of the switch front panel.

3 Remove the blank faceplate from the slot to make room for the module, if applicable.

NOTE

Any unoccupied module slot in the chassis should have a blank faceplate installed to ensure

satisfactory protection from EMI and to guarantee adequate airflow through the chassis.

4 Place the ESD bag containing the I/O module on a flat ESD surface, clean from any debris.

5 Break any seals on the bag.

6 Open the ESD bag and firmly grasp the rail of the module.

7 Holding the rail of the module, pull the ESD bag off the module.

NOTE

By holding the rail of the module and pulling the ESD module off the module, you will prevent

damage to the module that might be caused by sliding the module on the ESD surface.

CAUTION

To prevent ESD damage, handle the module by the metal panel edges only. Never touch the

components on the PCB or pins on any of the connectors.

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 87 88

Sin comentarios

Extreme Networks BlackDiamond 10808 Guía de instalación Pagina 58