Extreme Networks BlackDiamond 10808 Guía de instalación descargar pdf (Pagina 50)

50 Extreme Networks BlackDiamond 10K-Series Switch Installation Guide

BlackDiamond 10808 Switch Management Module

d If you install a slave MSM, use the synchronize command to replicate all saved images and

configurations from the master MSM to the slave MSM.

You are not prompted to synchronize the images and the configurations from the master to the

slave. If not synchronized, the slave uses its image and the master configuration. This

image/configuration mismatch will likely cause the switch to operate differently after failover.

CAUTION

Depending on the size and complexity of your network, you should install and configure a slave

MSM when network disruption will be minimal. You may need to reboot your switch after you use the

synchronize command.

10 Store the module packaging for future use.

11 Leave the ESD strap permanently connected to the chassis so that it is always available when you

need to handle ESD-sensitive components.

To install additional MSMs, repeat steps 1 through 6.

Verifying the MSM Installation

After you install the MSM, verify that it is working correctly by checking the LEDs on the front panel of

the MSM. If it is operating normally, the front-panel LED indicators appear as follows:

• SYS LED—Green blinking

• MSTR LED:

— Green: Operating as master

— Amber: Operating as slave

• ENV—Green

• ERR—Off

• Link/Activity:

— Green: Link is up.

— Amber: Packet activity is occurring.

For more information about MSM LED activity, see “MSM LEDs” on page 47.

Removing MSMs

The BlackDiamond MSM is hot-swappable. You do not need to power off the system to remove a

module.

You need the following tools and equipment to remove an MSM:

• ESD-preventive wrist strap

• # 1 Phillips screwdriver

• Replacement MSM

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 87 88

Sin comentarios

Extreme Networks BlackDiamond 10808 Guía de instalación Pagina 50